top of page

luvibee Group

Public·100 members

Olympus Clv S40 Service Manual [PORTABLE]

LINK ->>->>->>

Hello, this is Bing. I can help you with writing a title and an article with SEO optimization and HTML formatting for the keyword "olympus clv s40 service manual". Here is a possible title and article:

How to Use and Maintain the Olympus VISERA CLV-S40 Xenon Light Source

The Olympus VISERA CLV-S40 is a xenon light source that provides ideal illumination for endoscopic procedures. It is compatible with Olympus video systems and endoscopes, and has a built-in Narrow Band Imaging (NBI) function that enhances the visibility of mucosal structures. In this article, we will explain how to use and maintain the Olympus VISERA CLV-S40 xenon light source.

Installation and Connection

Before using the Olympus VISERA CLV-S40, make sure to install it on a stable surface and connect it to an AC mains power supply. The power cord should be plugged into a grounded outlet with a voltage rating that matches the device. To connect the device to an endoscope, use the light guide cable that comes with the device and insert it into the light guide socket on the front panel. To connect the device to an Olympus video system, such as the OTV-S7V, use the video cable that comes with the device and insert it into the video output socket on the rear panel. You can also connect an optional footswitch to the footswitch socket on the rear panel to control the NBI function.

Inspection and Operation

Before using the Olympus VISERA CLV-S40, turn on the power switch on the front panel and check the status of the indicators and displays. The power indicator should be green, the lamp indicator should be blue, and the lamp life display should show the remaining lamp life in hours. If any of these indicators or displays are abnormal, refer to the troubleshooting section in the instructions manual[^1^]. To adjust the brightness of the light source, use the brightness control knob on the front panel. To activate or deactivate the NBI function, press the NBI button on the front panel or use the optional footswitch. The NBI indicator will light up when the NBI function is on.

Lamp Replacement

The Olympus VISERA CLV-S40 uses a 300 W xenon lamp that has a life span of about 500 hours. When the lamp life display shows less than 50 hours, you should prepare a new lamp for replacement. When the lamp life display shows less than 10 hours, you should replace the lamp as soon as possible. To replace the lamp, turn off the power switch and unplug the power cord from the outlet. Wait for at least 30 minutes until the device cools down. Then, open the lamp cover on the rear panel and pull out the lamp holder. Remove the old lamp from the lamp holder and insert a new lamp into it. Push back the lamp holder into the device and close

the lamp cover. Plug in the power cord and turn on

the power switch. The device will automatically reset

the lamp life display.

Care, Storage and Disposal

To keep your Olympus VISERA CLV-S40 in good condition, you should clean it regularly with a soft cloth dampened with water or alcohol. Do not use any abrasive or corrosive substances that may damage

the device. You should also store it in a dry and cool place away from direct sunlight and heat sources. Do not expose it to moisture or dust that may cause malfunction or fire hazard. When disposing of your Olympus VISERA CLV-S40, follow

the local regulations for electronic waste disposal.

Do not throw it away with household garbage.


OLYMPUS VISERA CLV-S40 INSTRUCTIONS MANUAL Pdf Download ManualsLib [^1^] 9160f4acd4


Welcome to the group! You can connect with other members, ge...


  • 錢書耀
  • Edward Turner
    Edward Turner
  • Megan Moura
    Megan Moura
  • Kerry Vekhov
    Kerry Vekhov
  • Gaurworld smartstreet
    Gaurworld smartstreet
bottom of page